9523- Electronics assemblers, fabricators, inspectors and testers

Electronics assemblers perform some or all of the following duties:


Solder and manually assemble various electronic components such as resistors, diodes, transistors, capacitors, integrated circuits, switches, wires and other electronic parts to designated locations on printed circuit boards
Assemble microcircuits requiring fine hand assembly, the use of microscopes and adherence to cleanroom procedures
Install, mount, fasten, align and adjust parts, components, wiring and harnesses to subassemblies and assemblies using hand and small power tools
Operate automatic and semi-automatic machines to position, solder and clean prescribed components on printed circuit boards
May replace defective components and repair and overhaul older devices.
Electronics fabricators perform some or all of the following duties:


Operate and monitor process equipment including automatic and semi-automatic machines to fabricate electronic components, solder, clean, seal and stamp components and perform other process operations as specified
Set up process equipment and adhere to cleanroom procedures as required.
Electronics inspectors perform some or all of the following duties:


Inspect electronic components and assemblies to ensure correct component selection and placement, wiring and soldering quality, proper pin insertions, location and diameter of plated holes, breaks in circuitry and line spacing in printed circuit board and other specified requirements while products are being assembled or fabricated
Check final assembly for finish, labelling and packaging methods
Check mechanical dimensions and perform "go-no-go" electrical tests
Identify and mark acceptable and defective assemblies and return faulty assemblies to production for repair
Collect, record and summarize inspection results
Investigate equipment malfunction and instruct on proper operation.
Electronics testers perform some or all of the following duties:


Operate various test equipment and tools to perform simple electrical and continuity testing of electronic components, parts and systems
Set up and operate automatic testing equipment to locate circuit and wiring faults, shorts and component defects
Compare test results to specifications and set parts or products aside for repair or replace components or parts as indicated by test equipment
May conduct life tests (burn-ins) on components, subassemblies and assemblies
Maintain test result reports.